How Clean Sticky Rubber On Nikon Camera Body
One of the mutual bug with the Nikon D70, and many older Nikon 35mm SLRs, is the rubber on the grip breaks down and becomes viscous. Unless fixed, the viscous grip makes the camera unusable. The tacky feeling makes the camera uncomfortable to concur and will leave a residue on your hands. I tried one-half a dozen dissimilar chemicals, but the merely thing that worked was 70% isopropyl booze (rubbing booze). It was not a quick fix, but 90% isopropyl alcohol may have worked faster. Keep in mind, there is no fixing the rubber. The isopropyl booze will remove the safe that has cleaved downward and get sticky. To remove the sticky safety, you're going to demand lots of paper towels. Get a paper towel damp with the isopropyl alcohol and gently wipe the sticky prophylactic. You want the grip to exist damp. The isopropyl alcohol will slowly break down the safety. Afterward 20-thirty seconds, wipe off the grip and run into if information technology is nevertheless sticky. If it is, repeat the process. (I spent 15 minutes doing this.) Rubbing hard does not speed up the process. Instead, the paper towel is going to intermission downwardly and your grip volition exist covered past newspaper towel fibers. Make sure to do this in a well ventilated area. The isopropyl alcohol will requite off fumes. Wearing rubber gloves is also a expert idea to foreclose the skin on your hands from getting very dry. Also, exist conscientious because both are combustible. You can find isopropyl booze, also known as rubbing alcohol, in the first aid department of any pharmacy. It is used to sterilize equipment and cuts. The other 30% or x% is distilled water. So you could weaken the strength of what you buy with distilled water. I went with 70% because information technology was what I had on hand. 70% produces fewer fumes. It is also less probable to cause harm, such as removing a stop or printing, if apply to clean/disinfect something. 90% will be safe for use on a camera. It should besides work faster. Merely exist careful if yous use it on something else. Every bit mentioned previously, both are flammable. The 90% is more full-bodied, so information technology carries a slightly college risk. The sticky grip is caused past the prophylactic breaking down. This can be due to the rubber aging, beingness in a hot environs, or from long exposure to sunlight (UV). For condom that has completely broken down, you'll have to remove all of it. This is common on the dorsum of 35mm SRLs, similar the Nikon N70. If you need to remove all of the safe, find a slice of plastic you can scrape the safety off with. Subsequently a few minutes of exposure to the rubbing booze I didn't utilise either of these because they are strong solvents. Y'all'll need to be outside or have agile ventilation if you use them. Y'all should also habiliment gloves to protect your pare. In add-on to removing the safe, they can also damage the plastic on the photographic camera body. If yous endeavour to utilise either chemical, test a small patch on the bottom of the camera to make sure they won't damage the plastic. I would not recommend using them. I occasionally apply naphtha to make clean lens elements. Information technology is highly volatile, and not pleasant to be around. The rubbing alcohol is "combustible" while lighter fluid is flammable . Keep that in heed for storage as well as use.
70% Isopropyl Alcohol Worked...
The Process I Used
Where to Find Isopropyl Booze (Rubbing Alcohol)
70% vs 90%
Other Chemicals Tested
Why the Rubber Becomes Sticky
Chemicals I Didn't Test
Source: https://www.outsidetheshot.com/fix-nikon-d70-sticky-rubber-grip/
Posted by: philipstheares.blogspot.com
0 Response to "How Clean Sticky Rubber On Nikon Camera Body"
Post a Comment